古典吧>英语词典>pawl翻译和用法

pawl

网络  棘爪; 制转杆; 掣爪; 卡爪

复数:pawls 

英英释义

noun

  • a hinged catch that fits into a notch of a ratchet to move a wheel forward or prevent it from moving backward
      Synonym:detentclickdog

    双语例句

    • A toothed wheel or rack engaged with a pawl that permits it to move in only one direction.
      连接着棘爪的只能允许朝一个方向运动的齿轮或齿轮架。
    • The fastening tool further includes a coil feeder ( 720) assembly having an indexing pawl ( 722).
      紧固工具还包括具有分度棘爪的卷料进给组件。
    • The feasibility for rolling special section pawl steel with the existing& 180 mm mill at laboratory has been discussed.
      研究了用180mm轧机轧制异型断面棘爪钢的可行性。
    • The virtual prototype of the clutch is built based on Pro/ E and the switch process of the SSS clutch is simulated by MSC Adams. The simulation of the impact performance of the pawl and pawl wheel and the engaging performance of the middle part is finished.
      利用Pro/E及MSCADAMS建立该离合器的虚拟样机模型,并在MSCADAMS中对离合器动态接合过程进行仿真,分析棘轮棘爪的碰撞特性,以及中间件的啮合特性。
    • If the cup plug is missing, the park pawl anchor shaft can move out of position under certain conditions.
      如果该杯状固定塞脱落,驻车止动爪定位销可能在特定情况下滑移出正常位置。
    • The pawl type bamboo roots grab was designed.
      竹爪式竹根挖掘机方案设计。
    • And adjusting the friction torque between the ratchet wheel and pawl can effectively increase the code discrimination performance of micro-electromechanical system code lock.
      通过控制棘轮棘爪处的摩擦力矩可有效提高微机电系统密码锁的鉴码性能。
    • Design characteristics of pawl pole permanent synchronous machine
      爪极永磁同步电机的设计特点
    • The blades are positioned on the large handle by a rotating shaft screw, and the pushing pawl and a pawl torsion spring are connected with the small handle through the pawl pin.
      小手柄上通过棘爪销柱连接有推进棘爪及棘爪扭簧,推进棘爪受到棘爪扭簧的压力始终压制在刀片的齿上;
    • The fine blanking dies of the pawl and the chute used for the seat recliner were firstly introduced in this thesis, and failure analysis has been carried out in view of mechanical calculation, metallographic test, hardness test and SEM.
      本文首先针对棘爪、滑槽板两副精冲模具出现断裂的凸模,从力学强度校核、金相试验、硬度试验、断口电镜扫描等进行试验分析。