silencers

英 [ˈsaɪlənsəz]

美 [ˈsaɪlənsərz]

n.  (发动机的)消音器; (枪支的)消音器
silencer的复数

柯林斯词典

• N-COUNT (枪支的)消音器
  Asilenceris a device that is fitted onto a gun to make it very quiet when it is fired.
  1. ...a pistol that was equipped with a silencer.
     装了消音器的手枪
• (汽车排气管上的)消音器
  Asilenceris a device on a car exhaust that makes it quieter.

in AM, use 美国英语用 muffler

双语例句

• The sound source and microphones are arranged reasonably, so that the transmission loss of silencers with high gas flow velocity and the flow generated noise inside the silencer can be measured on the test-bed.
  设计并搭建了消声器声学性能测量试验台，合理布置声源及传声器，使该台架可用于高流速情况下消声器传递损失以及消声器内流噪声的测量。
• Meanwhile, a specialized engine intake silencer and exhaust silencers test bench was designed to testify the relationship between aspect ratio and resonant frequency.
  同时设计了发动机进气消声器性能测试专用实验台，从实验角度研究了腔体截面纵横比与共振频率之间的关系。
• The function of acoustics and dynamic characteristics of dissipative silencers are tested. Computers, data collection boards, sensors and software are used to get the characteristics.
  对阻性管道消声器的声学性能与动态特性进行了测试试验研究，采用计算机、数据采集卡、传感器和处理软件测试得到阻性消声器的动态特性。
• The predicted transmission loss of perforated tube silencers using the finite element method and experimental results are compared and showed good agreement.
  使用有限元法计算穿孔管消声器的传递损失，并与实验测量结果进行了比较，二者吻合良好。
• Numerical analysis of the effect of structural parameters on the acoustic attenuation performance of straight-through perforated tube silencers
  结构参数对直通穿孔管消声器消声性能影响的数值分析
• Comparisons of transmission loss predictions with experimental results for straight through perforated tube dissipative silencer illustrated that FEM can predict acoustic characteristics of perforated tube silencers accurately.
  直通穿孔管阻性消声器传递损失的有限元预测结果与实验测量结果吻合很好，表明了三维有限元法预测穿孔管阻性消声器声学性能的适用性和精度。
• Finally, the transmission loss results of straight-through perforated tube silencers with partially-perforated tube and divided tube are calculated and analyzed. Some conclusions are drawn according to these results, which supply guidance for silencer designs.
  最后计算并分析了中心管部分穿孔和带有分隔管的直通穿孔管消声器的传递损失，得出一些结论，为消声器设计提供指导。
• A substructure method and a dual reciprocity boundary element method ( DRBEM) are applied to calculate four-pole parameters and transmission loss of ducts and silencers with complex flow.
  将子结构法和双倒易边界元法联合应用于预测具有三维复杂流存在时管道和消声器的四极参数与传递损失，阐述其基本原理与数值过程。
• On this basis structural optimization of two silencers are put up, and specific design scheme and structural dimensions are determined. Process water silencer and put up experimental research.
  在此基础上进行了两种消声器的结构优化设计，并确定了具体的设计方案和结构尺寸，设计加工了可变频消声器的原理样机，进行了实验研究。
• The rear silencers can be replaced individually by disconnecting the system.
  断开系统后，可以单独更换尾部消音器。